Operation Manual

min.
300
mm
min.
300
mm
min.
600
mm
min.
300
mm
min.
700
mm
min. 600
mm
A
B
C
D
C
F
A
E
X
3
IN
IN
OUT
F
1
F
2
X
4
“F1” 340
“F2” 514
ENGLISH
EN - 20
 

 
mode.
2.6.2 - Outdoor unit assembly
Proceed as follows (as described in the previous paragraph), once the ideal position for installation of the

a 
b. Screw any clamping nuts, without tightening completely.
c. Using a spirit level, check the unit is level; if necessary, adjust the support feet.
d. Tighten any clamping nuts correctly.
IN = air inlet - OUT = air outlet
Model
DUAL
INVERTER 14
1x2
e. If the outdoor unit is higher than the indoor units, to prevent rain entering, a downward bow must be made
along the connection pipe (siphon) before the connection pipe enters the wall. This is to guarantee that
the lowest point of the connection pipe is outdoors.
340
514
DUAL
INVERTER 18
1x2