Operation Manual

ENGLISH
EN - 32
3.4.11 - LED/FOLLOW ME key (11)
 Press this key for less than 2 seconds to start the LED function.
If the key is held down for more than 2 seconds, the FOLLOW ME function is activated.
 Press the LED key to reset the air conditioner digital display; press it again to activate it.

When the air conditioner is put in “AUTO” mode, these will automatically select cooling, heating or fan,
depending on the temperature that has been selected and the room temperature.
Once the operational mode has been selected, the functioning conditions are stored in the memory of the
unit microcomputer and the air conditioner starts to function in the same conditions, when simply pressing
the “ON/OFF” key of the remote control.
START
Check that the unit is connected and is powered electrically.
a. Press the “MODE” key (1) to select “AUTO” mode.
b. Set the desired temperature by pressing the “TEMP” keys (4).
Normally the temperature is between 21°C and 28°C.
c. When the remote control is “OFF”, press the “ON/OFF” key (2) to start the air conditioner.
STOP
a. Press the “ON/OFF” key (2) to stop the air conditioner.
If the AUTO mode is not wanted, the desired conditions can be selected manually.
When AUTO mode is selected, the fan speed does not have to be set; the fan speed is controlled
automatically.

START
Check that the unit is connected and is powered electrically.
a. Press the “MODE” key (1) to select the “COOL”, “HEAT”, or “FAN ONLY”. mode.
b. Set the desired temperature by pressing the “TEMP” keys (4).
Normally the temperature is between 21°C and 28°C.
c. When the remote control is “OFF”, press the “ON/OFF” key (2) to start the air conditioner.
d. Press the fan speed key (FAN “5”) to select “AUTO”, “LOW”, “MED”, or “HIGH”.
e. When the remote control is “OFF”, press the “ON/OFF” key (2) to start the air conditioner.
The FAN ONLY mode does not adjust the temperature, therefore, to select this mode, only perform the “a”,
“c”, “d”, “e” phases.
STOP
a. Press the “ON/OFF” key (2) to stop the air conditioner.
If the AUTO mode is not wanted, the desired conditions can be selected manually.
3.5 - ADJUSTING AIR FLOW DIRECTION

generating irregular temperatures in the room.
a. Adjust the horizontal louvres using the remote control.
b.