Instructions / Assembly

Installation

Fig. 1 Fig. 2 Fig. 3

Filter Housing Assembly

Remove main system bracket, 3 lters and housings from packaging and assemble the lter

housings onto the main system bracket as follows:

I. Install Filters into Housings: See Fig. 1. Stand 3 housings upright. Check each housing

to ensure the black O-ring is properly seated in its groove.

Remove the plastic from the Polypropylene Sediment Filter and place into the 1st

Stage housing.

Remove the plastic from both Carbon Block Filters and place into the middle (2nd

Stage) and left (3rd Stage) housings.

II. Install Housings onto System: See Fig. 2. Starting with the 1st Stage housing on the

right, hand twist the housing onto the main bracket turning clockwise under the 1st

Stage label. Using the provided large wrench, completely tighten the 1st Stage hous-

ing onto the main system bracket. One at a time, hand twist and then tighten with the

provided large wrench, the 2nd Stage and 3rd Stage housings under their corrospond-

ing labels on the main system bracket. See Fig. 3. Once all three housings are installed,

stand system upright.