User Manual

Connecting the camera to a computer and a printer
6
142 EN
Direct printing ( PictBridge)
By connecting the camera to a PictBridge-compatible printer with the USB cable, you
can print out recorded pictures directly.
• RAW images and movies cannot be printed.
1
Connect the camera to the printer using the supplied USB cable.
Micro-USB connector
Smaller terminal
USB cable USB port
• Use a fully charged battery for printing.
• When the camera is connected to a printer via USB, a dialog should be displayed in
the monitor prompting you to choose a host. If it is not, select [Auto] for [USB Mode]
(P. 122) in the camera custom menus.
2
Use FG to select [Print].
• [One Moment] will be displayed, followed by a print-
mode selection dialog.
• If the screen is not displayed after a few minutes,
disconnect the USB cable and start again from Step 1.
Storage
Exit
Print
MTP
USB
Set
3
Follow the operation guide to set a print option.
Selecting the print mode
Select the type of printing (print mode). The available print modes are as shown below.
Print
Prints selected pictures.
All Print
Prints all the pictures stored in the card and makes one print for
each picture.
Multi Print
Prints multiple copies of one image in separate frames on a single
sheet.
All Index
Prints an index of all the pictures stored in the card.
Print Order
Prints according to the print reservation you made. If there is no
picture with print reservation, this is not available.