User Manual
Cautions
7
152
EN
3
Adjust the settings for each group in the RC mode display.
250
A Mode
TTL
Manual
Off
+5.0
TTL +3.0
1/8
–
Low
1
Ch
1023
F5.6250
P
1:02:03
Flash intensity value
Group
• Select the fl ash control
mode and adjust the fl ash
intensity separately for
each group. For MANUAL,
select the fl ash intensity.
Normal fl ash/Super FP fl ash
• Switch between normal
fl ash and Super FP fl ash.
Communication light level
• Set the communication
light level to [HI], [MID],
or [LO].
Channel
• Set the communication
channel to the same
channel used on the fl ash.
Flash intensityFlash control
mode
Adjust settings for the
camera fl ash unit.
4
Press the fl ash pop-up button to raise the fl ash.
• After confi rming that the fl ash has charged, take a test shot.
Wireless fl ash control range
Position the wireless fl ash units with their remote sensors facing the camera. The following
illustration shows the approximate ranges at which the fl ash units can be positioned. The
actual control range varies with local conditions.
• We recommend using a single group of up to
three remote fl ash units.
• Remote fl ash units cannot be used for second
curtain slow synchronization exposures longer
than 4 seconds.
• If the subject is too close to the camera,
the control fl ashes emitted by the camera
fl ash may affect exposure (this effect can be
reduced by reducing the output of the camera
fl ash by, for example, using a diffuser).
7m
5m
100°100°
50°
50°
50°
50°
60°
60°
30°
30°
30°
30°
• The upper limit of fl ash synchronization timing is 1/160 sec. when using the fl ash in RC
mode.