Product Manual

2
Figure 1 - Omega Wheel Arm™ Nomenclature
SAFETY AND GENERAL INFORMATION
Save these instructions. For your safety, read, understand, and follow the information provided with and on this
device before using. The owner and/or operator shall have an understanding of the device, its operating characteristics
and safety operating instructions before operating the equipment. The owner and/or operator shall be aware that use
and repair of this product may require special skills and knowledge. Instructions and safety information shall be read
to and discussed with the operator in the operator's native language, making sure that the operator comprehends
their contents, before use of this equipment is authorized. If any doubt exists as to the safe and proper use of this
device, remove from service immediately.
Inspect before each use. Do not use if abnormal conditions such as cracked welds, damaged, loose or missing
parts are noted. Any equipment that appears damaged in any way, is found to be worn, or operates abnormally shall
be removed from service until repaired. If the equipment has been or is suspected to have been subjected to an
abnormal load or shock, immediately discontinue use until inspected by a factory authorized repair facility (contact
distributor or manufacturer for list of authorized repair facilities).
PRODUCT DESCRIPTION
The Omega Wheel Arm™ is designed to clamp onto the lift arms of a 2-Post Lift, and support an automobile wheel
of no more than 100 lbs. The upward slope and plastic stop will ensure that the wheel does not slip off while being
supported by the Omega Wheel Arm™. There is a reinforced rubber hose on the support bar to ensure no damage
occurs to the rim of the wheel. The Omega Wheel Arm™ is designed to t many, but not all 2-Post LIfts.
WARNING: Never hang on the Omega Wheel Arm™ or use it to support any bodily load.
PREPARATION
Before Use
1. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
2. Verify that the product and application are compatible, if in doubt call Omega Technical Service [phone].
3. Determine the height and width of the 2-Post Lift beam, and verify that the corresponding dimensions are stamped
on the Omega Wheel Arm™.
!
Support Arm
Bottom Plate
Rear Plate
Front Plate
Ball Support
M8 x 1.25 x 16
(with threadlocker)
Qty. of 1
M8 x 1.25 x 12
Qty. of 4
Socket Head Screws
M8 x 1.25 x 14
Qty. of 2