INSTRUCTION MANUAL 7 series Automatic Wrist Blood Pressure Monitor ENGLISH ESPAÑOL Model BP652
TABLE OF CONTENTS Before using the Monitor Introduction ......................................................................................................... 3 Safety Information ................................................................................................ 4 Operating the Device .......................................................................... 4 Care and Maintenance .........................................................................
INTRODUCTION Thank you for purchasing the OMRON® BP652 IntelliSense® Automatic Wrist Blood Pressure Monitor. Fill in for future reference. DATE PURCHASED:__________________ SERIAL NUIMBER:___________________ s 3TAPLE YOUR PURCHASE RECEIPT HERE s 2EGISTER YOUR PRODUCT ON LINE AT WWW REGISTER OMRON COM The monitor is compact and easy-to-use at home, at work, and during travel. Perfect for people who frequently monitor their own blood pressure.
SAFETY INFORMATION To assure the correct use of the product, basic safety measures should always be followed including the warnings and cautions listed in this instruction manual. SAFETY SYMBOLS USED IN THIS INSTRUCTION MANUAL WARNING Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
SAFETY INFORMATION Do not use a cellular phone near the device. It may result in an operational failure. Use only Omron authorized parts and accessories. Parts and accessories not approved for use with the device may damage the unit. 8VH RQO\ 9 ³$$$´ DONDOLQH EDWWHULHV ZLWK WKLV GHYLFH 'R QRW XVH RWKHU W\SHV RI batteries. This may damage the unit.
BEFORE TAKING A MEASUREMENT To ensure a reliable reading follow these recommendations: 1. Avoid eating, drinking alcohol, smoking, exercising, and bathing for 30 minutes before taking a measurement. Rest for at least 15 minutes before taking the measurement. 2. Stress raises blood pressure. Avoid taking measurements during stressful times. 3. The cuff can be applied to your left or right wrist. 4. Measurements should be taken in a quiet place. 5. Position the unit at heart level throughout the measurement.
KNOW YOUR UNIT Main Unit: Display Wrist cuff Memory (MEM) button START/STOP button Date/Time setting ( ) button User ID selection switch SET button Date/Time setting ( ) button Battery compartment Components: INSTRUCTION MANUAL 7 series Automatic Wrist Blood Pressure Monitor Model BP652 5329415-9A INTRODUCTION Thank you for purchasing the OMRON ® BP652 IntelliSense® Automatic Wrist Blood Pressure Monitor . Fill in for future reference.
UNIT DISPLAY Positioning indicator Diastolic blood pressure Memory symbol (Displayed when viewing values stored in memory) Average value symbol (Refer to “Using the Memory Function” .) Irregular heartbeat symbol Systolic blood pressure Deflation symbol Movement error symbol (Displayed if you move your body during the measurement) Blood pressure level indicator Buzzer symbol User ID symbol (A or B) (If ³GUEST´ is selected, A or B will not be displayed.
DISPLAY SYMBOLS IRREGULAR HEARTBEAT SYMBOL ( ) When the monitor detects an irregular rhythm two or more times during the measurement, the Irregular Heartbeat Symbol ( ) will appear on the display with the measurement values. $Q LUUHJXODU KHDUWEHDW UK\WKP LV GH¿QHG DV D .ORMAL (EARTBEAT rhythm that varies by less than 25% from the Pulse average rhythm or 25% more than the average Blood rhythm detected while the monitor is measuring pressure the systolic and diastolic blood pressure.
DISPLAY SYMBOLS This is a general guideline because blood pressure depends on age and morbidity. A lower home blood pressure goal may be recommended for certain patients, including diabetic patients, pregnant women, and patients with renal failure. WARNING &RQWDFW \RXU SK\VLFLDQ IRU VSHFL¿F LQIRUPDWLRQ DERXW \RXU EORRG SUHVVXUH Self-diagnosis and treatment using measured results may be dangerous. Follow the instructions of your physician or licensed healthcare provider.
BATTERY INSTALLATION CAUTION 8VH RQO\ 9 ³$$$´ DONDOLQH EDWWHULHV ZLWK WKLV GHYLFH 1. Press the hook on the bottom of the battery cover and lift the cover off in the direction of the arrow. ,QVWDOO ³$$$´ VL]H EDWWHULHV VR WKH SRVLWLYH DQG (negative) polarities match the polarities of the battery compartment as indicated. 3. Set the date and time. 5HIHU WR ³6HWWLQJ WKH 'DWH DQG 7LPH´ 4. Replace the battery cover. NOTE: Make sure that the battery cover is securely in position.
BATTERY INSTALLATION BATTERY REPLACEMENT Low Battery Indicator When the Low Battery Indicator appears on the display, turn the monitor off and remove all the batteries. Replace with 2 new batteries at the same time. Long-life alkaline batteries are recommended. WARNING ,I EDWWHU\ ÀXLG VKRXOG JHW LQ \RXU H\HV LPPHGLDWHO\ ULQVH ZLWK plenty of clean water. Contact a physician immediately.
SETTING THE DATE AND TIME 6HW WKH PRQLWRU WR WKH FXUUHQW GDWH DQG WLPH EHIRUH WDNLQJ D PHDVXUHPHQW IRU WKH ¿UVW time. 1. TO START THE SETTING Press the Date/Time Setting button ( ) to adjust the date and time. 7KH \HDU ÀDVKHV RQ WKH GLVSOD\ 2. SETTING THE YEAR Press the Date/Time Setting button ( ) to advance by increments of one year. Press the Date/Time Setting button ( ) to set the current year. 7KH PRQWK ÀDVKHV RQ WKH GLVSOD\ NOTES: 7KH \HDU FDQ EH VHW EHWZHHQ DQG 2030.
SETTING THE DATE AND TIME 4. SETTING THE DAY Press the Date/Time Setting button ( ) to advance by increments of one day. Press the Date/Time Setting button ( ) to set the current day. 7KH KRXU ÀDVKHV RQ WKH GLVSOD\ 5. SETTING THE HOUR The time is set using AM or PM. Press the Date/Time Setting button ( ) to advance by increments of one hour. Press the Date/Time Setting button ( ) to set the current hour. 7KH PLQXWH ÀDVKHV RQ WKH GLVSOD\ 6.
SETTING THE ADVANCED POSITIONING SENSOR (APS) You can change the options for various settings on your monitor. Pressing the SET button to change a setting. Press the MEM button to select the options for that setting. $IWHU VHOHFWLQJ D VHWWLQJ SUHVV WKH 67$57 6723 EXWWRQ WR FRQ¿UP WKH VHWWLQJ DQG WXUQ the power off. SETTING THE POSITIONING INDICATOR 1. Select your User ID. 2. Press the SET button.
SETTING THE ADVANCED POSITIONING SENSOR (APS) SETTING FOR RIGHT OR LEFT WRIST MEASUREMENT 1. While in the setting mode, press the SET button until the wrist symbol ( or ) appears on the display. 127(6 7KH GHIDXOW VHWWLQJ LV ³ ´ $IWHU \RX FKRRVH ³R))´ IRU WKH Positioning indicator, the monitor skips this process. 2. Press the MEM button to select the left wrist ( ) or the right wrist ( ). SETTING THE BUZZER 1.
SETTING THE ADVANCED POSITIONING SENSOR (APS) ,I WKH 3RVLWLRQLQJ LQGLFDWRU LV ³RQ ´ RU ³RQ ´ on1: The buzzer sounds only when the monitor is in proper position. on2: The buzzer sounds a series of two short blips if your wrist is too far away from the measuring position, and beeps when your wrist is in the proper position. oFF: The buzzer will not sound. ,I WKH 3RVLWLRQLQJ LQGLFDWRU LV ³R))´ on: The buzzer sounds when pressing any buttons. oFF: The buzzer will not sound.
APPLYING THE WRIST CUFF CAUTION Read all of the information in the instruction manual and any other literature in the box before operating the unit. CAUTION This device is intended for use in measuring blood pressure and pulse rate in the adult population. Do not use this device on infants or persons who cannot express their intentions. APPLYING THE CUFF ON THE LEFT WRIST 1. Roll up sleeve. Make sure your sleeve is not rolled up too WLJKWO\ RQ \RXU DUP 7KLV PD\ FRQVWULFW WKH ÀRZ RI EORRG in your arm. 2.
APPLYING THE WRIST CUFF 5. Fold the remaining part of the wrist cuff back out of the way. APPLYING THE CUFF ON THE RIGHT WRIST When taking a measurement using the right wrist position the cuff as shown in the illustration.
TAKING A MEASUREMENT The monitor is designed to take measurements and store the measurement values in memory for two people using USER ID A and USER ID B. The monitor can be used to WDNH D VLQJOH PHDVXUHPHQW XVLQJ WKH *8(67 PRGH DUH QRW VWRUHG LQ WKH PHPRU\ 6LW FRPIRUWDEO\ LQ D FKDLU ZLWK \RXU IHHW ÀDW RQ WKH ÀRRU 2. Select your User ID (A or B). User A 3. Hold your arm across your chest at heart level.
TAKING A MEASUREMENT 5. Press the START/STOP button. All symbols appear on the display. 7KH FXII VWDUWV WR LQÀDWH DXWRPDWLFDOO\ $V WKH FXII LQÀDWHV WKH PRQLWRU DXWRPDWLFDOO\ GHWHUPLQHV \RXU LGHDO LQÀDWLRQ OHYHO 7KLV PRQLWRU GHWHFWV \RXU EORRG SUHVVXUH DQG SXOVH UDWH GXULQJ LQÀDWLRQ The Heartbeat Symbol ( ÀDVKHV DW HYHU\ KHDUWEHDW Remain still and do not move until the entire measurement process is completed.
USING THE MEMORY FUNCTION Every time you complete a measurement the monitor stores the blood pressure and pulse rate for each user (A and B) in the memory. The monitor automatically stores up to 100 sets of measurement values (blood pressure and pulse rate) for each user (A and B). When 100 sets of measurement values are stored, the oldest record is deleted to save the most recent values.
USING THE MEMORY FUNCTION NOTES: 7KH GDWH DQG WLPH DUH DOWHUQDWHO\ GLVSOD\HG ZLWK WKH PHDVXUHPHQW values. 3UHVV WKH 0(0 EXWWRQ UHSHDWHGO\ WR GLVSOD\ WKH QH[W YDOXHV 3UHVV DQG KROG WKH 0(0 EXWWRQ WR GLVSOD\ WKH YDOXHV IDVWHU 3. Press the START/STOP button to turn the monitor off. TO DELETE ALL VALUES STORED IN THE MEMORY The values stored in the memory are deleted by User ID. You cannot partially delete values stored in the memory. All values for the user you select will be deleted. 1.
CARE AND MAINTENANCE To keep your digital blood pressure monitor in the best condition and protect the unit from damage, follow the directions listed below: Do not forcefully bend the cuff. Do not fold tightly. Clean the monitor with a soft dry cloth. Do not use any abrasive or volatile cleaners. Do not attempt to clean the cuff. CAUTION Do not submerge the device or any of the components in water. Do not subject the monitor to extreme hot or cold temperatures, humidity or direct sunlight.
ERROR INDICATORS SYMBOL CAUSE CORRECTION Monitor could not detect pulse wave. &XII XQGHU LQÀDWHG Cuff not applied correctly. Take another measurement and remain still until the measurement is complete. Remove the monitor from your wrist. 5HDG ³7DNLQJ D 0HDVXUHPHQW´ &XII RYHU LQÀDWHG Wait 2-3 minutes. Take another measurement. Device error. Contact Customer Service. Movement during measurement. Keep still and take another measurement. Irregular or weak pulses are detected.
TROUBLESHOOTING TIPS PROBLEM CAUSES AND SOLUTIONS No power. No display appears on the unit. Replace both batteries with new ones at the same time. Check the battery installation for proper placement of the battery polarities. Measurement values appear too high or too low. Blood pressure varies constantly. Many factors including stress, time of day, how you wrap the cuff, may affect your blood pressure.
FCC STATEMENT Note: POTENTIAL FOR RADIO/TELEVISION INTERFERENCE (for U.S.A. only) This product has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
LIMITED WARRANTY Your BP652 IntelliSense® Automatic Wrist Blood Pressure Monitor, excluding the wrist cuff and batteries, is warranted to be free from defects in materials and workmanship appearing within 5 years from the date of purchase, when used in accordance with the instructions provided with the monitor. The above warranties extend only to the original retail purchaser. We will, at our option, repair or replace without charge any monitor or wrist cuff covered by the above warranties.
SPECIFICATIONS BP652 (HEM-6052-Z) LCD Digital Display Pressure: 0 to 299 mmHg, Pulse: 40 to 180/min. Pressure: ±3mmHg or 2% of reading Pulse: ±5% of reading Automatic by electric pump Inflation: Automatic pressure release valve Deflation: Automatic exhaust valve Rapid Air Release: Measurement Method: Oscillometric method 9 ³$$$´ EDWWHULHV Power Source: Approx.
Omron Healthcare, Inc. 1200 Lakeside Drive Bannockburn, IL 60015 www.omronhealthcare.com Copyright © 2010 Omron Healthcare, Inc.