Ethernet Units Operation Manual

ManualsBrandsOmron ManualsNetwork CardCS/CJ Series

Mounting to a PC Section 3-5

When using the automatic generation method for address conversion, set the

node number to the same value as the rightmost byte of the local IP address.

If this is not possible, then either the IP address table method or the combined

method must be used for address conversion. For details, refer to 4-2 CPU

Bus Unit System Setup.

If the FINS communications service is not being used over the Ethernet net-

work, then there is no problem if the node number duplicates that of another

Ethernet Unit. The node number must still be set from 01 to 7E, however, or

the ERC indicator will light.

Note Turn OFF the power supply before setting the node number.

3-5 Mounting to a PC

3-5-1 Mounting to a CS-series PC

Ethernet Units can be mounted to any slots in either a CS-series CPU Rack or

a CS-series Expansion CPU Rack, but the number of slots to which they can

be mounted depends on the Backplane. Up to four Ethernet Units can be

mounted to a single PC. If it is mounted in combination with other CPU Bus

Units (e.g., Controller Link Units), the maximum total number of CPU Bus

Units that can be mounted is 16.

Note Tighten PC Backplane mounting screws to a torque of 1.2 N

⋅m, and the Unit’s

screws to a torque of 0.8 N

⋅m.

Note The CS1W-ETN01/ETN11 Ethernet Unit’s maximum current consumption is

400 mA. (The power provided to the transceiver is not included because it

comes from a 24-VDC power supply connected to the Unit’s power supply ter-

minals.) Make sure that the total current consumption of all the Units con-

nected to the same CPU Backplane or Expansion Backplane does not exceed

the output capacity of the Power Supply Unit.

CS1W-BC023/BC033/BC053/BC083/BC103 CPU Backplane

CS-series CPU Rack

Can mount to any position,

with 2, 3, 5, 8, or 10 slots.

CS1W-BI033/BI053/BI083/BI103 CS-series Expansion Backplane

CS-series Expansion Rack

Up to four Units can be mounted

to the slots shown in the diagrams

on the left.

3, 5, 8, or 10 slots

Can mount to any position,

with 3, 5, 8, or 10 slots.

2, 3, 5, 8, or 10 slots

(Expansion Backplane not possible with 2-slot CPU Backplane.)

C200H Expansion I/O Backplane

Ethernet Unit cannot be

mounted to any slots.

CPU: CPU Unit

PS: Power Supply Unit

CPU

C200H Expansion Rack