Operation Manual

Preparation and Wall Mounting

Preparing the Remote Control

• irst push to inside as the direction indicated by the arrow (See 1) and then Remove the

battery holder as the direction indicated by the arrow (See 2).

• Replace the battery Set a new battery property with (+)side up as illustrated (See 3).

• Insert the battery holder. Push in the holder to the original position (See 4).

Using the Remote Control

Face the remote control towards the player front face IR mark (remote control signal receiver).

Operation angle: About 30 degree in each the direction of the front of the IR mark.

Note: The lithium cell in the battery compartment of remote control has been secured for

transport with a foil. Before initial use please remove this foil so that the remote control is

ready for operation.

Attaching the Stand

Turn the unit over as shown below, and align the mounting blocks on the top of the stand, with

the mounting openings located on the bottom of the main unit. Once in place, the 4 mounting

tabs on the stand will align with the 4 rectangular mounting slots located on the bottom of the

unit. Make sure the mounting tabs are lined up with the slots, and slide the stand towards the

front of the unit until the mounting stand it is fully inserted, and locked in place. Make sure the

base is locked rmly in place, so it does not come o.

To remove the stand, use both hands to hold the stand, and using two ngers, lift the two locking

tabs marked with arrows to unlock the base. Slide the stand towards the back of the unit to un-

lock. When the stand is in unlock position, pull the stand upward to remove it.