Owner's Manual
Table Of Contents
- Instruction Manual
- Reset
- Bluetooth PIN (0000)
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Speaker Layout
- Connect the Speakers
- Connect the TV & AV Components
- Initial Setup with Auto Start-up Wizard
- AV Component Playback
- Bluetooth Playback
- Listening to Internet Radio
- Spotify
- AirPlay
- USB Storage Device
- Listening To the AM/FM Radio
- Music Server
- Multi-zone
- Setup Menu
- Audio Menu
- Web Setup
- Firmware Update
- Troubleshooting
- Specs
- Quick Start Guide
- Spec Sheet
- Firmware Update Information
- Sonos Connect Supplemental Manual
- Chromecast Built-in Support
- FireConnect Support
- Play-Fi Support
- Warranty
6
Rear Panel
1. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio signals
with a digital optical cable or digital coaxial cable.
2. ETHERNET jack: Connect to the network with an Ethernet cable.
3. USB jack: A USB storage device is connected so that music files stored in it can be
played. You can also supply power (5 V/500 mA) to USB devices with a USB cable.
4. Wireless antenna: Raise for Wi-Fi connection or when using a BLUETOOTH wireless
technology enabled device. Adjust their angles according to the connection status.
5. TUNER AM/FM 75≠ terminals (North American models): The supplied antennas are
connected.
6. HDMI OUT jack: Connect a HDMI cable to transfer video signals and audio signals to a
TV.
7. HDMI IN jacks: Input video signals and audio signals with a HDMI cable connected to an
AV component.
8. REMOTE CONTROL jack: An Onkyo product with RI jack can be connected and
synchronized with this unit (P13).
9. IR IN/OUT terminals: Connected to the multi-room remote control kit. Special devices or
cables are necessary. For more information about preparation, contact the specialized
stores.
10.
AC INLET: Connect the supplied power cord.
11.
GND jack: The ground wire of the turntable is connected.
12.
AUDIO IN jacks: Input AV component audio signals with an analog audio cable.
TUNER DAB/FM terminal (European models): The supplied antenna is connected.
13.
ZONE 2 LINE OUT jacks: Output audio signals with an analog audio cable to a pre-main
amplifier in a separate room (ZONE 2).
14.
SUBWOOFER PRE OUT jacks: Connect a powered subwoofer with a subwoofer cable.
Up to two powered subwoofers can be connected. The same signal is output from each of
> Before Start >Part Names > Install > Initial Setup > Playback
Advanced Setup | Supplementary Information | Others
180°
90°
(European models)