Owner's Manual

4. Do not shut the unit off until “Complete” is shown on the front display. This
will take up to 30 minutes.
5. Once the update has completed check the firmware version to confirm that
the unit is fully up to date. If it is not, run the update again.
To check the firmware version, press the SETUP button on the front
panel. Highlight “8.Misc” and press enter. Highlight “8.3 F/W Update” and
press Enter. Scroll down to the Firmware Version number to verify the
current installed version.
Current Version 1020-2000-0010-0008
How to upgrade the firmware via Network:
1. If the unit is connected via LAN and there is firmware update available, the
"Firmware Update Available" message may appear. To execute updating,
select "Update Now" with the cursor buttons of the remote controller and
press ENTER. The unit automatically turns itself into standby mode about
30 minutes after "Completed!" appears on the display, and updating will
be complete.
2. Alternatively, to force an update, select “SETUP” on the front panel, then
scroll and select “8.Misc”,  “F/W Update”  “Update Via NET” and press
ENTER.
● If "Firmware Update" is grayed out and cannot be selected, wait
for a while until it starts up.
● You will not be able to select "Update via NET" if there is nothing
to update.
3. Press ENTER with "Update" selected to start update.
● During the update, the TV screen may go black depending on the
updated program. In that case, check the progress on the display of
the unit. The TV screen may remain black until the update is
complete and the power is turned on again.
● "Completed!" is displayed when the update is complete.
4. Press ON/STANDBY on the main unit to turn the unit into standby mode.
The process is completed and your firmware is updated to the latest
version.
● Do not use RECEIVER on the remote controller.
Current Version
1020-2000-0010-0008