Operation Manual

101
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Playing Back
Set the remote controller to the ZONE control mode (ZONE 2/ZONE 3)
( p99, 100), and then perform the following operations.
1. Point the remote controller at the unit, and press .
• "Z2" or "Z3" on the display of the main unit lights up.
• ZONE 3 cannot be turned ON unless "2. Speaker" - "Conguration" - "Zone
Speaker" in the Setup menu ( p132) is not set to "Zone 2/Zone 3".
2. Press the input selector of the input source you want to play in the separate
room. To control on the main unit, press ZONE 2 button or ZONE 3 button, and
then within 8 seconds, press the input selector button of the input to be played
in the separate room. To play the same source in the main room and separate
room, press ZONE 2 button or ZONE 3 button of the main unit twice.
3. If the unit is connected to the pre-main amplier in the separate room, adjust
the volume on the pre-main amplier. If the unit is connected to the power
amplier or ZONE speaker in the separate room, adjust the volume on the
remote controller. To do this on the main unit, press ZONE 2 button or ZONE
3 button, and then within 8 seconds, adjust the volume using the MASTER
VOLUME dial.
• When adjusting the volume of the power amplier placed in the separate
room by using this unit, set "6. Multi Zone" - "Zone 2" (or "Zone 3") - "Output
Level" ( p146) to "Variable" on the Setup menu.
• The sound quality of the power amplier connected in the separate room
can also be adjusted. Press the ZONE 2 button of this unit, and then press
the TONE button within 8 seconds. Then turn the TONE dial for adjustment.
• Information of a connected device can be displayed on the TV in the
separate room. Set the remote controller to the ZONE control mode (ZONE
2), and then press .
• If you turn the unit to standby during multi-zone playback, the Z2 or Z3
indicator is dimmed, and the playback mode is switched to playback in a
separate room only. Setting ZONE 2/ZONE 3 to on while the unit is in standby
also switches the playback mode to playback in a separate room only.
• For ZONE 2 output, audio from externally connected AV components can