Operation Manual

149
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
 AccuEQ
AccuEQ Room Calibration: Enable or disable the equalizer function that
corrects for sound distortion caused by the acoustic environment of the room.
To enable this setting, normally select "On (All Ch)", and to disable only the front
speakers, select "On (ex. L/R)". The setting can be set for each input.
Equalizer: Select "Preset 1" to "Preset 3" congured in "2. Speaker" - "Equalizer
Settings" in the Setup menu. When this is set to "O", the same sound eld
setting is applied to all ranges.
EQ for Standing Wave : Setting this "On" will control the eect of the standing
wave generated by the sound wave reected by wall or similar interfering with the
original sound wave.
Re-EQ, Re-EQ(THX): Adjusts the soundtrack with the enhanced high range so
that it suits a home theater.
In Re-EQ, the following listening modes can be used: Dolby Audio - DD, Dolby
Audio - DD+, Dolby Audio - DSur, Dolby Audio - TrueHD, Multichannel, DTS,
DTS-ES, DTS 96/24, DTS-HD High Resolution Audio, DTS-HD Master Audio,
DTS Neural:X, DTS Express and DSD.
In Re-EQ(THX), the following listening modes can be used:
THX Cinema and THX Select Cinema.
• It cannot be set if the listening mode is Pure Audio or Direct.
 Other
A/V Sync: If the video is behind the audio, you can delay the audio to oset the
gap. The setting can be set for each input.
• It cannot be set if the listening mode is Pure Audio or Direct.
Music Optimizer: Improve the quality of the compressed audio. Playback sound
of lossy compressed les such as MP3 will be improved. The setting can be set
for each input. This works in signals whose sampling frequencies are 48 kHz or
less. The setting is not eective in the bitstream signals.
• It cannot be set if the listening mode is Pure Audio or Direct.
Late Night: Enable small sounds to be easily heard in detail. It is useful when
you need to reduce the volume while watching a movie late night. You can enjoy
the eect only when playing the Dolby series and DTS series input signals.
• This function cannot be used in the following cases.
– When playing Dolby Digital Plus or Dolby TrueHD with "Loudness
Management" set to "O"
– When the input signal is DTS:X, and "Dialog Control" is not 0 dB
Center Spread: Adjust the width of the sound eld of the front channel when
playing in the Dolby Audio - DSur listening mode. To spread the width of the
sound eld to the right and left, set to "On". To concentrate the sound in the
center, set to "O".
• Depending on the speaker settings, "O" is applied.
Dialog Control: You can increase the volume of dialog portion of the audio up to
6 dB by 1 dB step so that you can hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not be selected.
HDMI Out: Select the HDMI OUT jack to output video signals from "MAIN",
"SUB", and "MAIN+SUB".