Owner manual

Chapter 1 Installation

1. Each module shall be installed from bottom to top, the default setting of the system is module No. 1,

2, 3, 4, 5, 6, 7, 8, 9, and 10.

2. Insert the module into installation position, and push in the cabinet. The wiring terminals in between

shall be tight, and excessive force shall be prevented against the damage to inserted pins of the

terminals.

3. Fix the module to the cabinet though the mounting holes on two sides of the front plate of the

module.

固定孔

A处放大

固定孔

A处放大

Fig 1-8 Power Module Installation Diagram

1.4.8 Cable Entry

Cables can enter the UPS from top and below as shown in fig 1-9. Both the top and bottom of the

UPS have cable entrance.

The recommended installation practice is to install power cables in the entrance channel

at both sides of the cabinet back door, so as not to affect the ventilation.

进线通道

Fig 1-9 Cable Entry Diagram

Power module

Fixing hole

Amplification of A

Cable entrance