Operation Manual

6
GB
Note: Steps 7~10 will not operate if there is no battery for the
radio.
HOW TO USE THE ALARM
Press the[ ON/OFF]. To activate or deactivate an alarm, when the
alarm is not active the [ ] will not be displayed.
SNOOZE FUNCTION
When the snooze function is activated, the alarm will be muted
temporarily and set off again after eight minutes. To disable the
snooze function, press [ ON/OFF].
Note: The snooze function will only operate in Beep-Alarm mode.
The snooze function will not operate in the Radio-Alarm mode.
SECTION 3 THE RADIO
HOW TO USE THE RADIO
To turn on the radio, press [RADIO]. The last selected radio frequency
will be shown.
To change the frequency,
1. Press [AM/FM] to select AM or FM.
2. Use TUNING [
] / [ ] to locate the desired frequency.
Press once to advance 1 step, press and hold to auto search the
next channel.
To change the volume, use VOLUME [
+ ] / [ - ] .
To select a programmed channel, press [STATION]
To turn off the radio, press [RADIO].
AUTO SEARCH FUNCTION
The RRM112A is equipped with the Auto Search function; the unit
will automatically search for the next clear channel.
To use the auto search function,
1. Press and hold TUNING [
] / [ ] to activate the auto search
function,
2. The frequency increases or decreases until a clear channel is
found.
Note: User may release the key during the tuning process
HOW TO PROGRAM A CHANNEL
The unit allows you to program up to 8 FM and 8 AM radio stations.
To do so,
1. Turn on the radio.
2. Press [AM/FM] to select AM or FM.
3. Select the desired station number using [STATION].
4. Use TUNING [
] / [ ] to locate the desired frequency.
5. Press and hold [STATION] for two seconds to confirm.