Outback Power VFX Series Installation Manual

6
AC WIRING ORIGINATION
Lexan cover protects AC Wiring
Compartment Board
AC WIRING COMPARTMENT BOARD
AC HOT OUT supplies power to the loads.
AC NEUTRAL OUT acts as neutral leg for loads
supplied by the FX.
CHASSIS GROUND connections are common
and act as grounds for both the incoming and
outgoing AC circuits.
AC NEUTRAL IN acts as the neutral leg for AC
power supplied by either the grid or a generator
to the FX.
AC HOT IN connects incoming AC from the grid or
a generator to the FX. This AC is used to run loads
and recharge batteries.
NOTE: “CHASSIS GROUND” in the AC terminal
block reads as “NEU/GROUND BOND” ON FX
MOBILE SERIES (see page 21).
NOTE: 6 AWG (4.11 mm) is the largest wire
size the AC Wiring Compartment Board can
accommodate.
AC HOT OUT
AC NEUTRAL OUT
CHASSIS GROUND/PE
CHASSIS GROUND/PE
AC NEUTRAL IN
AC HOT IN
BATTERY
FULL OK LOW
STATUS
INVERTER
AC IN ERROR
BATTERY TEMP
MATE/HUB
INVERTER ON/OFF
INVERTER
ON/OFF
AUX+
AUX-
XCT-
XCT+
AC Terminal Block--secures AC
connections to the FX using set screws
AC Wiring Board
M