Installation Guide

Installation
16 900-0168-01-00 Rev C
Mounting

One person can install the FXR inverter, but installation may be easier with two people.

The unit
has four mounting holes, one in each corner. Use fasteners in all corners for a secure installation.
IMPORTANT:
Use correct fasteners to secure the inverter to the mounting surface,
regardless of the type of surface. OutBack cannot be responsible for
damage to the product if it is attached with inadequate fasteners.

Due to the variance in other mounting methods, OutBack only endorses the use of FLEXware mounting
products or previous versions of OutBack mounting plates. Use M6 x 20 mm machine screws, one per
corner, to attach the inverter to the mounting plate. Follow the instructions with each mounting system.

Mount and secure each component before attaching any wiring.

When the inverter is used with other metal chassis, make sure that all chassis are grounded appropriately.
(See the grounding instructions on page 18.) Grounding other chassis may involve metal-to-metal contact,
or separate ground wires.
If using an OutBack FLEXware Mounting Plate, avoid large air gaps behind the plate. These can result
in louder mechanical noise during heavy inverting or charging. Mount the plate on a flat, solid
mounting surface.
Dimensions
Figure 4 Dimensions
Height
with Turbo
33 cm (13”)
Width
21 cm (8.25”)
Length 41 cm (16.25”)
Height
without
Turbo
30.5 cm (12”)