Installation Manual

Installation
22 900-0168-01-00 Rev C
DC Cover or Turbo Fan Attachment
Figure 10 DC Cover Attachment
Figure 11 Turbo Fan Wiring
If it is necessary to remove the Turbo Fan:
1. Remove the compartment cover.
2. Unscrew the AUX+ and AUX– terminal screws.
3. Remove the wires.
4. Remove the screws at the four corners of the Turbo Fan.
5. Remove the Turbo Fan.
COVER ATTACHMENT
FXR inverters are equipped with either the DC Cover
or the Turbo Fan. To attach either cover, put the
cover in place and insert a screw at each corner
using a Phillips screwdriver.
As part of attaching the Turbo Fan, follow the wiring
instructions in Figure 11.
TURBO FAN WIRING
Install the wires in the AC Wiring Compartment to
make the Turbo Fan operational. The AUX+ and
AUX– terminals receive the red (+) and black (–)
wires. Tighten with a Phillips screwdriver.
To safely run the wires into the AC compartment,
pass the wires through the notch in the
compartment cover.
If necessary, the green terminal block can be unplugged
b
y
pulling it gentl
y
awa
y
from the AC board.
Make certain the AUX programming is
correct for proper fan operation.
Notch
Compartment
Edge of Cover