Installation Guide

ManualsBrandsOutback Power ManualsInverterOutback Power Radian GS7048E Export Inverter

Installation

900-0144-01-01 Rev B

Component Mounting

Figure 10 Mounting for System Components

For the FLEXmax charge controller:

To fit on the Radian inverter’s right side, the FLEXmax

charge controllers require the FW-CCB or FW-CCB2

mounting brackets. To accommodate many possible

mounting requirements, four sets of mounting holes

have been provided for the brackets.

For the MATE3:

To fit on the Radian inverter’s

left side, the MATE3 requires

the FW-MB3 mounting

bracket. Holes are provided

on the upper and lower left

side to attach the FW-MB3.

For more information, see the

FW-MB3 instruction sheet.

For the HUB:

To fit on the Radian inverter’s left side,

the HUB Communications Manager

uses two mounting holes and

three knockouts.

The top of the GS Load Center (GSLC) connects to the bottom

of the Radian inverter using four keyhole slots. The keyhole

slots fit over four screws on the bottom of the inverter that

secure the GSLC to the inverter when they are tightened. (The

long screwdriver recommended on page 13 may

be needed to reach these screws.) The GSLC should

be secured to the wall using screws or wall anchors.

The GSLC also makes a mechanical connection to the

Radian using bus bars that bolt to the inverter’s DC

terminals. Other connections are wired as necessary.

Several system components can mount directly onto the

Radian inverter or the GSLC. The MATE3 System Display and

the HUB Communications Manager can easily be mounted on

the left side of the system. Up to two FLEXmax 60 or 80 charge

controllers can be mounted on its right side.

NOTE

: The FLEXmax controller requires mounting brackets

(see below). The conduit provided with these brackets is long

enough to wire the FLEXmax directly to the GSLC. Additional

conduit may be necessary when mounting on the inverter.

The image on the right shows GSLC mounting. See Figure 2 on

page 4 for other configurations.

NOTE: The OutBack FLEXmax Extreme should be installed on the wall to either side of the

GSLC for direct wiring access and does not require additional brackets.