Outback FX-R Series Installation Manual

Installation
22 900-0166-01-01 Rev A
DC Cover or Turbo Fan Attachment
Figure 10 DC Cover Attachment
Figure 11 Turbo Fan Wiring
If it is necessary to remove the Turbo Fan:
1. Remove the screws at the four corners of the Turbo Fan.
2. Remove the compartment cover.
3. Unscrew the
A
UX
+ and
A
UX
– terminal screws.
4. Remove the wires.
5. Remove the Turbo Fan.
COVER ATTACHMENT
FXR inverters are equipped with either the
DC Cover or the Turbo Fan. To attach
either cover, put the cover in place and
insert a screw at each corner using a
Phillips screwdriver. Make certain the red
and black battery terminals are installed
before attaching the cover.
As part of attaching the Turbo Fan, follow
the wiring instructions in Figure 11.
TURBO FAN WIRING
Install the wires in the AC Wiring Compartment to
make the Turbo Fan operational. The
A
UX
+
and
A
UX
– terminals receive the red (+) and black (–)
wires. Tighten with a screwdriver.
To safely run the wires into the AC compartment,
pass the wires through the notch in the
compartment cover.
If necessary, the green terminal block can be
unplugged by pulling it gently away from the AC board.
Make certain the
A
UX
programming is
correct for proper fan operation.
Notch
Compartment
Edge of Cover