Outback FX-R Series Installation Manual

Introduction

900-0166-01-01 Rev A

Figure 2 Components

DCC (DC Cover)

This covers the DC terminal area on vented inverters.

The DCC provides space to mount other components

such as a DC current shunt.

AC Plate

This plate is used for installations which do not utilize

OutBack’s optional FLEXware conduit boxes. The

knockouts are used to install strain relief for flexible cable.

NOTE: This plate is not to be connected to conduit.

Battery Terminal Cover

These protect the terminals from accidental contact. They

are made of stiff plastic with a snap-on design.

Always keep covers installed during normal operation.

Turbo Fan Cover

Included in place of the DCC on sealed inverters. Convectively

cools chassis with the external OutBack Turbo Fan to allow

maximum power.

NOTE: Do not install the Turbo Fan on a vented inverter.

NOTE: The DC Cover or Turbo Fan does not replace the

battery terminal covers. These covers must be installed in

addition to the DCC or Turbo Fan.