Installation Guide

STEP 1 – Dig Post Holes and Set Posts
STEP 2 – Install Rails
STEP 3 – Attach Post Caps
Dig post holes 12" 18" in diameter and 30" to 45" deep (depending on local ordinance or
expected frost depth in winter). Keep the height of the rails in mind when digging your post
holes. We recommend a minimum of 6" between the bottom rail and the ground.
Backfill the holes with 6" of gravel.
Starting in the corner, mix concrete in the first hole per the instructions on the bag. Mix
thoroughly and install the post into the hole and tap the post to the proper depth.
Using a level, ensure post is plumb. Brace the post with temporary supports as the concrete
sets (per the instructions).
Follow these steps to install the remaining posts.
©2019 Universal Forest Products, Inc. All rights reserved.
68956 U.S. Hwy 131, White Pigeon, MI 49099 616.365.4201 10736_8/19
www.ufpi.com
VINYL RANCH RAIL FENCE – INSTALLATION INSTRUCTIONS
Insert the rail into the bottom hole
in the first routed post, as far as it
will go.
Slide the other side of the rail into
the bottom hole in the next routed
post, engaging the locking tab.
Work your way up, sliding rails into
the remaining routed holes. Repeat
steps until all rails in each section
are installed.
Attach one post cap to each post using PVC cement.
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION
OR USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE
CONSTRUCTION OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT,
INCLUDING, BUT NOT LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT
PROVIDE ANY OTHER WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
30"– 45"
deep
6" minimum
12"-18" hole
diameter
6" of gravel