Installation Guide

10
2
1. Insertthexedpanel’sbottomsealstrip(I)atthebaseofthexedglasspanel(A),40mm(19/16in)fromthe
panel’s edge.
2. Place the sliding door guide (E) on the base. Ensure the distance that is shown in the image (2).
3. Mark the positions of holes of the sliding door guide (E) with a pencil, and drill pilot holes with a ø3mm (1/8in) drill
bit.
4. Fix the sliding door guide (E) with the screw (BB) and cap (KK). Ensure the plastic gasket in the guide is in place as
itprotectsthexedglasspanel
5-6. Placethexedglasspanel(A)intothewalltrack(B)andtheslidingdoorguide(E).
Note: The wall track (B) allows you to adjust the position of the xed glass panel (A). Adjusting the depth and/
or giving the xed glass panel a slight angle allows for precise alignment with the door.
7-8. Oncealladjustmentshavebeenmade,drillthexedpanel(A)withΦ3mm(1/8in)in3places,securethewall
track(B)usingscrews(AA),ttingsandcaps(FF).
FIXED PANEL INSTALLATION
1
A
I
E
Helpful Hint
Add a drop of
silicone in the
holes before
inserting the
screws
41.6mm
1 5/8in
565mm
22 1/4in
3
Φ3mm
1/8in
4
5
6
KK
BB
E
B
A
A
E
AA
A
A
7
Φ3mm
1/8in
FF
8