Operation Manual

1.3 Safety information
To avoid the risk of fi re or damage to the device, the receiver must never be exposed
to moisture or rain.
Should an item or liquid get into the housing, immediately disconnect the de-
vice from the power supply and have it checked by a qualifi ed professional before
further usage.
Place the receiver in a place with suffi cient air circulation and away from
any heat sources. This will prevent heat accumulation inside the receiver and
ensures a longer lifecycle. Do not place any items on the receiver – malfunctions,
damage and even self-ignition may occur if the ventilation openings are blocked.
Should you ever notice an unusual smell or smoke, immediately disconnect the
device from the power supply and have it checked by a qualifi ed professional.
Switch off the receiver before connecting other devices. The power supply line to
the receiver must have a cross-section of 2.5 to 4,0 mm² and must be connected
directly to the vehicle battery. Ensure that the device is not connected to an elect-
ronic charge controller.
Keep a suffi cient distance to potential sources of interference such as mobile pho-
nes, electronic heater controllers, igniter components or radio devices when routing
the lines and positioning the components.
It is recommended that you ground your television set in the vehicle to avoid inter-
ference on your television set or satellite receiver. Only connect the freely accessible
ground of your television set to the vehicle chassis.
Only use the wiring harnesses supplied or the extension wiring harnesses available
as accessories to connect the top box. The extension wiring harnesses are available
for the Oyster® Digital system only.
6