Owner's manual

pg.5
Safety Warnings
Do Not lift any load that is not located directly below the crane. This product is not intended to drag a load
sideways.
Do Not wrap the load with the wire rope. Use only a sling or another manufacturer-approved device.
Do Not operate without 4 anchor wraps of wire rope around the winch drum.
Do Not push the ratchet jack handle beyond its travel limits. Ratchet jack should be tested separately from
the crane before use.
Do Not operate without assuring wire rope is securely attached to the winch drum.
Do Not operate without checking for proper lubrication.
Do Not put hands in areas with moving parts such as sheaves, wire ropes, and gears.
Do Not lift people.
Do Not lift loads over people.
Do Not operate until personnel are warned of approaching loads and are cleared from the area.
Do Not leave a suspended load unattended.
Do Not substitute smaller diameter pins. Use only the pins supplied with the crane.
Do Not operate or store the crane in an environment that exceeds 120 degrees Fahrenheit.
Do Not use chains, cables, or rigid devices to to lift crane. Nylon or other synthetic slings should be used
instead.
NOTE: This crane is non-conductive and is not electrically grounded. This crane has no static discharge
capabilities.
Safety Lanyard
Warnings & Precautions
A safety lanyard is included to reduce the risk of over-extending the ratchet binder on the CompOZite
Davit Crane. When tted onto the same pins that the ratchet binder attaches to, this lanyard is the same
length as the ratchet binder (when extended to its maximum safe operating length).
The safety lanyard is meant only as an indicator to the operator that they have lowered the boom of the
crane to its lowest operating position (i.e. extended the ratchet binder to its maximum length). It will not
prevent the operator from over-extending the ratchet binder as the ratchet binder can generate enough
force to overcome this lanyard. When the safety lanyard becomes taught, the ratchet binder has been fully
extended.