Product Manual
EN pg.7
Operation
Warnings & Precautions
Beam Clamp operators should read and fully comprehend this entire manual and all warnings on the hoist
before beginning hoist operation. If this manual is not read and followed completely injuries may occur.
Operator Requirements:
Must be trained in proper trolley operation and dealing with potential malfunctions.
Should not operate beam clamp while under inuence of alcohol, medications, or drugs.
Should not operate the beam clamp while tired or distracted.
Should not operate beam clamp if they have a history of seizures or other medical issues that may
interfere with operation.
Should have proper coordination and vision.
Prior to Operation be sure:
Clamp is in proper working condition and maintenance records are up to date.
Operation
1. Open the clamp jaw by turning counter clockwise.
2. Position the beam clamp on the girder.
3. To close the clamp jaw hand-tighten by turning the threaded spindle clockwise.
4. Be sure that the jaw fully clamps.
5. Ensure that the load is centered.
6. Always lift slowly and maintain constant observation of the load.
Maintenance
Operators should visually inspect girder clamps on a regular basis. Observe for wear, damage,
cuts, cracks, or corrosion. Verify that the spindle is freely moving. If any problems are observed the
beam clamp should be placed out of service until it can be repaired. Use only OZ Lifting products for
replacement parts.
Once a year the beam clamp should be taken to an authorized repair center for professional
inspection.
Following repair test the beam clamp with a load that is 1.25 times the rated load to re-certify the
product.