Product Manual

EN pg.7
Operation
Warnings & Precautions
Beam Clamp operators should read and fully comprehend this entire manual and all warnings on the
clamp before beginning clamp operation. If this manual is not read and followed completely injuries may
occur.
All Operators MUST:
• Be trained in proper clamp operation and in dealing with potential malfunctions.
• Abstain from use of alcohol, medications, or drugs while operating.
• Avoid operation while tired or distracted.
• Avoid operation if they have a history of seizures or other medical issues that may interfere with operation.
• Have proper coordination and vision.
NOTE: Prior to operation, ensure clamp is in proper working condition and maintenance records
are up to date.
Operation
1. Open the clamp jaw by turning spindle handle counter clockwise.
2. Position the beam clamp on the girder.
3. To close the clamp jaw hand-tighten by turning the spindle handle clockwise.
4. Be sure that the jaw fully clamps.
5. Ensure that the load is centered.
6. Always lift slowly and maintain constant observation of the load.
Maintenance
Operators should visually inspect girder clamps on a regular basis. Observe for wear, damage, cuts,
cracks, or corrosion. Verify that the spindle is freely moving. If any problems are observed, the beam clamp
should be placed out of service until it can be repaired. Use only OZ Lifting Products LLC® for replacement
parts.
The Beam Clamp should be taken annually to an authorized repair center for professional inspection.
Following repair, test the beam clamp with a load that is 1.25 times the rated load to re-certify the product.