Product Manual
EN pg.7
Installation
Check for damage during shipment prior to installation. Do not install or use a damaged product.
Be sure to maintain records of all accompanying product information. Contact your OZ Lifting Products
LLC® dealer if there are any problems or questions. Read and comply with all instructions and warnings
furnished with or attached to the product as applicable.
1. Open the clamp jaws by turning spindle handle counter clockwise.
2. Center the beam clamp on the girder.
3. Turn the spindle handle clockwise to close the clamp jaws.
4. Ensure that the jaws are tight enough that the beam clamp cannot slide on the beam.
5. Tighten the jam nut nger tight on the spindle so that it contacts the threaded pivot pin.
6. Tighten the jam nut an additional 1/8 to 1/4 turn with a wrench or other suitable tool.
NOTE: Please refer to the manuals of all other components of your personal fall arrest system to ensure
those components are being used properly and are in compliance with all applicable standards. The Beam
Clamp is not intended to slide on the structure it is installed upon.
Warning: Beam Clamp operators should read and fully comprehend this entire manual and all
warnings on the clamp before use. If this manual is not read and followed completely, injuries may
occur. Proper use of this beam clamp is only part of the safe operation of your personal fall arrest
system. Ensure that all components of your personal fall arrest system are being used correctly
and are in good condition.
All Persons MUST:
Be trained in proper operation and in dealing with potential malfunctions of personal fall arrest systems.
Abstain from use of alcohol, medications, or drugs while operating.
Avoid operation while tired or distracted.
Avoid operation if they have a history of seizures or other medical issues that may interfere with operation.
NOTE: Prior to operation, ensure that the Beam Clamp is in proper working condition and maintenance
records are up to date.Please refer to the manual for your specic fall protection device for proper
operation.
Maintenance, Cleaning and Storage
Ensure that the work area is free of debris, rot, rust, decay, cracking, and hazardous materials. A stable
work area is required for use.
Dirt, corrosives, and contaminants should be cleaned with water as necessary. Mild soap can be used if
necessary, though a thorough rinse and dry is mandatory. Lightly lubricate all moving parts after cleaning.
Never clean the Beam Clamp with corrosive substances.
Always store your Beam Clamp where it will not be subjected to heat, light, excessive moisture, chemicals,
or other elements.
1 2 3 4 5 6