Product Manual

EN pg.10
Inspection Chart
NOTE: Disassemble crane, including boom and winch, periodically to inspect each for damage. Use the
following chart to determine what type of inspection is necessary. Frequent Inspection (F) and Periodic
Inspection (P).
Location Check For F P
Crane Damage, cracks, rust, chipping, dents excess wear, or corrosion.
X
Unusual sounds
X
Smooth load movements
X
Equipment properly lubricated
X
Signs of overloading (cracks, dents, or damage)
X
Proper function when operated with a load equal to the load rating
X
Foundation Good condition/supports the crane under all conditions
X
Level, no swerving of boom
X
Cracks, corrosion, damage (check by removing crane base from foundation)
X
Fasteners
(including moutning fasteners)
Firmly installed
X
Properly tightened
X
Stripped threads, bent, or damage (check by removing crane from foundation)
X
Handle Rotates freely in both directions
X
NOTE: Please refer to the winch owner’s manual for the winch inspection chart.
Repairs
All repairs must have factory authorization. Contact OZ Lifting Products LLC
®
to prevent voiding of
the two-year limited warranty and potential damage. Perform recommended inspections to identify
which parts should be replaced. Only use OZ Lifting Products LLC® replacement parts. To order
replacement parts, contact your local OZ Lifting Products LLC® dealer. Please have the serial
number, part number and a description available when calling.
Load Rating
*OZ500DAV based on 3/16” wire rope.
*OZ1000DAV based on 1/4” wire rope.
*OZ2500DAV based on 3/8”wire rope.
Load Ratings (lbs.) 1st. Layer Mid Drum Full Drum
OZ500DAV
550 lbs. 550 lbs. 550 lbs.
OZ1000DAV
1000 lbs. 875 lbs. 550 lbs.
OZ2500DAV
2500 lbs. 2000lbs. 1550 lbs.
IMPORTANT! Load ratings will vary depending on
wire rope length and diameter.