Product Manual

EN pg.5
Do Not lower the boom below the horizontal position.
Do Not operate without checking for proper lubrication.
Do Not put hands in areas with moving parts such as sheaves, wire ropes, and gears.
Do Not lift people.
Do Not lift loads over people.
Do Not operate until personnel are warned of approaching loads and are cleared from the area.
Do Not leave a suspended load unattended.
Do Not substitute smaller diameter pins. Use only the pins supplied with the crane.
Do Not use chains, cables, or rigid devices to lift crane. Nylon or other synthetic slings should be used instead.
Initial Crane Inspection
Check for damage during shipment. Do not install or use a damaged product. Be sure to maintain
records of product information and contact your OZ Lifting Products LLC® dealer with any problems
that arise. Refer to applicable codes and regulations before installing equipment. Contact a qualified
professional to obtain structure and foundation specifications for product mounting.
Before installing, select a location where the crane is:
• Visible throughout its entire operation.
• Free of traffic and any possible operational interference.
• Positioned so the operator is clear of both the load and the path of the wire rope.
• Accessible for maintenance.
• Attached to a strong, level foundation that can properly support it under all conditions.
• Removed from any corrosive, flammable, explosive, or potentially damaging materials.
Installing the Base
NOTE: The accompanying bases for the TELE-PRO DAVIT CRANES by OZ Lifting Products LLC® are sold
separately through OZ Lifting Products LLC® dealers. They are necessary for proper operation of this product.
The base must be securely fastened to the foundation using appropriately sized coarse thread fasteners of at
least grade 5. Fasteners should be torqued according to the fastener manufacturer recommendations. Not all
crane bases use the same size fasteners. Each base has mounting holes that are sized for appropriate fasteners.
Use the largest diameter fastener that will fit in the mounting holes. Please contact the factory with any base
fastener questions.
Assure that mounting surface is located directly above a strong, level, solid foundation that supports the crane
under all circumstances.
Non-standard products that have been altered from the original design may require alternative fastening
requirements. Contact your OZ Lifting Products LLC® dealer for more information.