Product Manual

EN pg.7
NOTE: Further disassembly of the boom extension/retraction mechanism is not normally needed.
If full disassembly of the inner boom components is required, please contact the factory. Any
unauthorized removal of the inner boom components will void the warranty.
Installing the Cable
The OZ Lifting Products LLC® cable assembly that can be ordered with the TELE-PRO DAVIT CRANE
by OZ Lifting Products LLC® may come with a swaged ball on one end to facilitate easy assembly.
Standard bare end cable can also be used. The hardware for bare end cable installation is included.
Please refer to the accompanying winch owner’s manual for instructions on installing a bare end
cable.
To install the OZ Lifting Products LLC® supplied cable with swaged ball end:
1. Lay the cable out on a flat surface to ensure it is not knotted or looped.
2. Locate the ball end of the cable.
3. Locate the “keyhole” in the winch drum that accepts the ball end of the cable.
4. Thread the ball end of the cable over the load sheave pulley and towards the winch. The cable
retainer pin may need to be removed from the tip of the boom so the ball will pass over the sheave.
5. Insert the ball end fitting of the cable into the “keyhole” feature in the winch.
6. Ensure that the ball end of the cable slides into the slot in the “keyhole” and cannot be pulled out.
7. Manually spool at least 4 full wraps of cable onto the winch drum. There must be at least 4 full
anchor wraps of cable on the winch drum at all times.
8. Install cable-retainer pin by inserting into holes at the tip of the boom.
1.
5. 6.
2. 3. 4.
Assembly Diagram