Product Manual

pg.5
Technical Information
STAINLESS SERIES PUSH BEAM TROLLEY (1, 2 tons)
Specication
Bail and Wheel
Dimensions available at
www.ozliftingproducts.com
B A
C
D
PRODUCT CODE OZSS1PBT OZSS2PBT
Safe working load (lbs) 2,000 (lbs) 4,000 (lbs)
Adjustable ange width (in) 2.5–8 (in) 3.5–8 (in)
Max ange thickness (in) 1.06 (in) 1.06 (in)
A 13 (in) 13.22 (in)
Product dimensions B 9.68 (in) 10.86 (in)
C 9 (in) 10.55 (in)
D 5 (in) 5.9 (in)
Minimum radius curve (ft) 3.28 (ft) 3.60 (ft)
Net weight (lbs) 26.5 (lbs) 43 (lbs)
Pre-Installation
Check for damage during shipment. Do not install or use a damaged product. Contact your OZ Lifting
Products LLC® dealer if there are any problems.
Maintain records of all accompanying product information.
Before initial operation:
NOTE: Read and comply with all instructions and warnings furnished with or attached to the product, if
applicable.
Push Beam Trolley Installation
Measure the width of the beam that the trolley will be mounted on. Ensure that the beam is within the
adjustable ange width range of the trolley.
Connect the two sideplates together and adjust to suite the beam width.
With the sideplates installed onto the beam, rmly tighten the nuts on both sides of the trolley. Secure these
nuts with the second locknuts. Ensure that both sets of nuts are tight.