Product Datasheet/Brochure

© 2017 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 2
Rev. 122017
Lexus / Toyota Amp PRO
Retention of SOS
(Safety Connect / Lexus Enform)
Technical Bulletin
When using the AmpPRO to add aftermarket ampliers, and retention of the factory SOS system is
desired, there are a few important points to remember:
• If you are not using an aftermarket amplier on the front speakers, and you wish to mute audio when
SOS is active, the factory mute wire mentioned in the overview must be found and connected to the
Yellow / Black wire on the AP4-TY harness labeled “Mute Input From Telematics”. See "Method 1" in
the next section for further details.
• If you are using an aftermarket amplier on the front speakers and do not plan on running new speaker
wires to each speaker, your aftermarket amplier's front right output will be passed through the factory
SOS module. The factory SOS module cannot handle any more that 150w RMS (The engineers at
PAC have tested running 150w RMS through a Toyota SOS module for extended periods of time
without issue). See "Method 2" in the below for further details.
• If you are planning on running new speaker wires to each speaker, and wish to retain the SOS system,
or the aftermarket amplier is rated at higher than 150w RMS to the front speakers, you will need to
follow the steps outlined as "Method 3" on page 4.
SOS Retention Methods:
Prior to interrupting any of the wires between the factory amplier, factory telematics module, or
the speakers, activate the SOS and note which speaker (or speakers) play the SOS audio for later
use. For instance, if only the front right mid is playing the SOS audio and there are additional
front right speakers, if you connect to the wires for the front right tweeter at the amplier, the SOS
audio will not be retained. To retain the SOS in this instance, you must connect to the wires for
the front right mid.
Method 1 (ex: Subwoofer Only Install):
Method 1 is used in cases where the factory amplier will continue to power the front speakers and you
wish to mute the audio from the aftermarket ampliers when SOS is active.
• Extend a wire from the Yellow / Black "Mute Input From Telematics" wire to the SOS Mute Trigger wire
at the factory Safety Connect Module. Refer to the "Vehicle Connections" section for vehicle specic
information (page 5).
Method 2 (Amplifying Cabin Speakers):
Method 2 is used when wiring an aftermarket amplier to the front speaker outputs of the factory amplier
rather than running new speaker wires from the aftermarket amp straight to the front speakers. One of
the front right speaker outputs of the aftermarket amplier passes through the Safety Connect Module.
It is recommended to use an amplier that provides 150 watts RMS or less so that the factory telematics
module is not damaged due to excessive heat. If the front speaker output is in excess of 150 watts, use
Method 3 instead (page 4).
• If you are wiring an aftermarket amplier to the front speakers through the Telematics Module, it
will require running a wire from the AP4-TY harness Yellow / Black wire labeled "Mute Input From
Telematics" to a wire at the Safety Connect Module. Refer to the "Vehicle Connections" section for
vehicle specic information (page 5). Next, cut the front speaker outputs (and rear if applicable) to
the speaker wire outputs at the factory amplier and insulate the side that goes towards the amplier
(these wires will not be used). Wire the aftermarket amplier outputs to the appropriate remaining
speaker wires. See the example "Fig. 1" on the following page.