Owner's Manual

Table Of Contents

Complete Radio Replacement with

Integrated Climate Control Retention for select

2015-2018 Ford F150 and 2017-2018 Ford Super Duty

RPK4-FD2201

PAC-audio.com

Pacific Accessory Corporation

Page 12

Rev. V7

Date:020419

Mounting the Aftermarket Radio

Remove tab (LH & RH) for Double-DIN radio Install

(LH-Side bracket shown)

Mount radio to brackets using supplied screws

Attach included pocket to bottom of kit brackets

Mount radio to brackets using supplied screws

Testing and Verication

1. Turn the ignition on. The LED on the interface will turn on and the +12v accessory wire will turn on.

2. Turn on the radio and check balance and fade.

3. Verify that all SWC are functioning properly.

4. Verify that the programmable 12v+ output is functioning as intended (if connected).

5. Verify that all HVAC controls are functioning properly. If the A/C is not blowing cold air, please ensure that the ribbon cables

you installed are seated in their connectors properly. Once that is done you may have to drive the vehicle around with the

A/C on for up to 20 minutes in order to re-initialize it.

6. The LED & radio will turn off when the ignition is turned off.

PASSENGER AIRBAG

Toggle Factory

Reverse Camera

Views (Wide / Narrow)

Force Reverse

Camera

Force Front

Camera

Force Blind

Spot Cameras

(Left / Right / O )

Camera Control

1. If you have the VS41 connected, the cameras can be accessed at any time by using the four buttons you relocated from the

factory dash panel. See below for button assignments.

2. If the vehicle is equipped with a factory reverse camera, you can use the rst button in the bank of four, or the “Mode” button

on the SWC, to switch between wide and narrow view, whenever the vehicle is in reverse. PLEASE NOTE: The wide /

narrow switch does not function if the reverse camera has been forced. The vehicle must actually be in reverse for this to

function.

3. The default operation of additional cameras is: Blind Spot = on when vehicle moving and turn signal on, Front = Manual

Only (using push buttons on HVAC panel). Behavior of these cameras can be changed using the RadioPRO PC application

(see next section).