Owner's Manual

Complete Radio Replacement with
Integrated Climate Control Retention for select
2015-2018 Ford F150 and 2017-2018 Ford Super Duty
RPK4-FD2201
© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 15
Rev. V7
Date:020419
Restoring Interface Factory Settings
You can restore the interface to factory default settings by pressing and holding the programming button on the side of the module
until LED 1 starts blinking red. Once the LED starts blinking red, release the button. You must release the button while the LED is
blinking red in order to perform the reset.
This reset will restore the following settings to their factory defaults:
• SWC Mapping
• Programmable 12v+ Output (Latched)
• Front Camera and Blind Spot camera behavior
Troubleshooting
LED Pattern
State
Action
LED 1 solid red
Active
N/A
LED 1 flashing green
SWC Activity
N/A
LED 2 solid red
Programmable 12v output active
N/A
LED 1 flashing red
Resetting
N/A
LED 2 flashing amber
USB connected
N/A
Off No activity
Ensure Key is in ignition position. If so, verify
that there is 12v and ground on the yellow
and black wires.
1. Factory HVAC not working - Please be absolutely CERTAIN that the provided ribbon cables are seated properly and not
mis-aligned or installed backwards. Ensure that both HVAC boards are seated properly, and that the alignment tab for the
temperature knob is positioned properly according to the steps on Page 6 of this manual.
2. Steering wheel controls inoperable - Ensure that the DIP switches are set properly according to page 9 of this manual.
3. Reverse Camera inoperable - Ensure that the provided reverse camera retention harness is connected to both the vehicle
connector (the one behind he factory screen) and the aftermarket radio.
4. Camera view mode switching inoperable - This feature is not retained by the RPK4.2-FD2201.