Owner's Manual

Complete Radio Replacement with
Integrated Climate Control Retention for select
2015-2018 Ford F150 and 2017-2018 Ford Super Duty
RPK4-FD2201
© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 2
Rev. V7
Date:020419
Installation
1. Remove front dash panel from
vehicle by prying up on the top
dash panel with a plastic pry tool,
then removing the two 7mm screws
located under the top dash panel.
2. Remove the factory screen, SYNC
module (if equipped), and Audio
Control Module (ACM) using a 7mm
socket. These parts are no longer
needed. They can be stored away
in case you ever decide to re-install
the factory radio.
3. If vehicle is equipped with a
factory camera module,it must be
relocated. Remove the three nuts
securing it using a 10mm socket.
4. Place the top right mounting bracket
onto the previous bottom stud
mount, and loosely secure using
one of the factory 10mm nuts that
you removed in the previous step.
5. You can now secure the bottom of
the camera module by using a zip
tie or by using the fastener of your
choice. Once completed, nish
tightening the top nut from the
previous step.
This is the end of
part one. Please
continue to the next
page to begin part
two.
Part One: Disassembly of Factory Dash