Owner's Manual

Complete Radio Replacement with
Integrated Climate Control Retention for select
2015-2018 Ford F150 and 2017-2018 Ford Super Duty
RPK4-FD2201
© 2019 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 5
Rev. V7
Date:020419
Disassembly of Factory Dash Panel (cont.)
13. Remove the auxiliary button pad
(make sure the rubber button pad
comes with it) and set aside for later
use.
14. You may now take the remaining pieces of the dash panel, along with the (16) T10
screws - (12) 22mm and (4) 16mm - and (4) ribbon cables and store them away.
These will be needed if you ever decide to reinstall the factory radio. Please do
not randomly use these screws when assembling the aftermarket dash kit. Use
specied screws only
This is the end of
part two. Please
continue to the next
section to begin
part three.
Part Three: Assembly of Aftermarket Dash Kit
1. These are the components you
should have set aside from part two.
2. Install the hazard and traction
control switches into the new dash
kit as shown. Traction control switch
goes on the left and hazard switch
goes on the right.
3. Flip the panel over and install the
HVAC buttons as shown. Make sure
the alignment tabs set correctly.