Manual

ManualsBrandsPace-Edwards ManualsCarJR Series Toyota Hilux

Part #: JR-SERIES TOY HILUX INSTALL-0611

CANISTER PART # TR2059, FM2059

JACKRABBIT SERIES

RETRACTABLE HARD TRUCK BED COVERS

Tools Required for Assembly ........................... 2

Before You Start ...............................................2

Drain Hole Locations ......................................... 2

Packaging Contents .......................................... 2

STEP 1: Positioning Canister ........................... 3

STEP 2: Installing Rails.................................... 3

STEP 3: Repositioning Canister....................... 3

STEP 4: Install Tailgate end of Pull Strap.........4

STEP 5: Installing Clamps................................ 4

STEP 6: Lubricating & Placing Sweep Seals ... 5

STEP 7: Installing Drain Tubes......................... 5

STEP 8: Install Top Cover & Velcro .................. 5

Operating Instructions ....................................... 6

Helpful Maintenance Hints ............................... 6

Warranty Statement........................................... 7

TABLE OF CONTENTS

(800) 338-3697

www.paceedwards.com

Pace Edwards Company

2400 Commercial Blvd.

Centralia WA 98531

TOYOTA HILUX

INSTALLATION INSTRUCTIONS

(SP17)

(truck pictured may be

different than actual

application)

Summary of content (8 pages)

PAGE 1
JACKRABBIT SERIES RETRACTABLE HARD TRUCK BED COVERS TOYOTA HILUX INSTALLATION INSTRUCTIONS (truck pictured may be different than actual application) TABLE OF CONTENTS (800) 338-3697 www.paceedwards.com Pace Edwards Company 2400 Commercial Blvd. Centralia WA 98531 (SP17) Tools Required for Assembly ........................... 2 Before You Start ............................................... 2 Drain Hole Locations ......................................... 2 Packaging Contents ..........................
PAGE 2
TOOLS REQUIRED FOR ASSEMBLY: 7/16” wrench or socket #2 Phillips screwdriver Wire Cutters Tape measure Note: There should be no drilling into the truck body needed on most standard or full-size trucks . BEFORE YOU START: Read the instructions carefully before you start. These instructions are written for one-person installation. We have noted where briefly having an extra person’s assistance can make installation easier.
PAGE 3
STEP 1: POSITIONING CANISTER Remove the top cover from the canister box and set it aside for later installation. Perform a quick inventory to insure all parts are there. Be sure to check inside the small cardboard box for parts. You will need one or two support pieces (We suggest using the top of the box the Jackrabbit was shipped in.) to set in the truck bed approximately one foot from the cab that will go under the canister, raising the top of the canister above the bed rails by 2-3 inches.
PAGE 4
STEP 4: INSTALLING CLAMPS HARDWARE USED: Before shimming and installing the rail clamps make sure the canister is centered between the truck bed rails. Not all truck beds are square. Shims may be required to keep the rails parallel and from bowing out when the clamps are tightened.
PAGE 5
STEP 5: LUBRICATING & PLACING THE SWEEP SEALS Locate the sweep seals (rubber weather strips) on the rails. Apply Pace Edwards’ UV Protectant (or 303 brand protectant) to a rag and wipe the underside of the sweep seal and the top of the wear strip. RAIL Extend the cover to the tailgate. Use an Allen wrench if needed to carefully draw out the sweep seal (seal should be angled outwards toward the cover – not rolled in toward the bed rail). (Fig.
PAGE 6
OPERATING INSTRUCTIONS 1. To open the cover, turn the actuator knob clockwise 90o until it clicks in the open position. This retracts the latches into the handle and the cover is free to roll open into the canister. A tug on the pull strap will release the latch and allow the cover to lock into the rails. 2. To latch the cover in one of the mid-range positions, pull it back just beyond the position desired and allow the cover to retract until it latches into place.
PAGE 7
C O N G R AT U L AT I O N S ! On your purchase of a Pace Edwards Retractable Truck Bed Cover. We are confident that you will get many years of trouble free service from this accessory to your truck. Please take a moment to fill out the warranty registration form to activate warranty coverage of your truck bed cover. PACE EDWARDS PRODUCT WARRANTY PACE EDWARDS (hereinafter referred to as the MFG.
PAGE 8
2400 Commercial Blvd, Centralia, WA 98531 USA (360) 736-9991 (main) (360) 736-9992 (fax) (800) 338-3697 (toll-free) www.paceedwards.