Quick Guide


SYSTEM OPERATION
 TO CALL: PRESS or
 TO GRANT ACCESS TO A VISITOR: PRESS 9 (RELAY 1) OR PRESS 8
(RELAY 2)
 TO USE ACCESS CODE: PRESS THEN PRESS
4-DIGIT ACCESS CODE
 TO ESTABLISH TWO WAYS COMMUNICATION WITH THE SYSTEM FROM
THE PREMISE: PRESS , HEAR BEEP THEN PRESS
 TO ESTABLISH TWO WAYS COMMUNICATION WITH THE SYSTEM FROM
REMOTE SITE: CALL THE SYSTEM PHONE NUMBER, HEAR ONE SHORT
BEEP THEN PRESS
 TO EXTEND TALK TIME: PRESS AFTER THE TIME OUT WARNING
BEEP
 TO ENABLE /DISABLE CALL FORWARDING
LOCAL
: ENABLE: PRESS THEN 1 (71) OR 2 (72)
DISABLE: PRESS THEN 0
PREMISE PHONE
(see function code 98): ENABLE: PRESS OR ,
ONE SHORT BEEP, THEN PRESS 1 (71) OR 2 (72)
DISABLE: PRESS 0
UNLOCK CYCLE, UNLOCK HOLD, CLOSE DOOR
LOCAL:
 Press simultaneously then release, enter the 4-digit master code.
 Select 90 or 91, see table, then PRESS
PREMISE
:
PRESS , One short beep, then PRESS
9 ---- Unlock cycle relay #1 (open and close door)
8 ---- Unlock hold relay #1 (open and hold open door)
7 ---- Lock relay #1 (close door)
5 ---- Unlock cycle relay #2 (open and close door)
4 ---- Unlock hold relay #2 (open and hold open door)
3
----
Lock relay #2 (close door)
WIRING DIAGRAM
REMOTELY RELEASING THE DOOR FUNCTION CODE 96 MUST BE SET 1-9RINGS
CALL THE SYSTEM, YOU MUST KNOW THE SYSTEM’S PHONE NUMBER
PRESS and 4 digit master code. PRESS then PRESS
9 ---- Unlock cycle relay #1 (open and close door1)
8 ---- Unlock cycle relay #2 (open and close door 2)
CALL WAITING, FUNCTION CODE 96 MUST BE SET 1-9 RINGS
Call waiting beep will be heard, Press to transfer between the two calls

TWO WAYS TO LOG IN TO PROGRAMMING MODE
 Press simultaneously then release, enter the 4-digit master
code. Default master code = 0000.
A short beep if the master code is valid
A long beep if the master code is not valid
 Or Press on board round black button then then select the
function code from the table