Owner manual

ManualsBrandsPach and Company ManualsAccessories communicationAeGIS NPB9000 Series Manual

FUNCTION CODE LOCAL PROGRAMMING

LOCK OUT COUNT

(Default setting is 03 )

Minimum setting is 1 and Maximum

setting is 9 .

The system will ignore further

keypad code for 90 second if invalid

keypad code has been entered a

specific number of times.

Does not valid for card code or

combination between card code and

keypad code.

TONE OR PULSE

(Default setting is TONE)

Always set for TONE, no phone bill

will not work on pulse.

SINGLE OR MULTI SYSTEMS

(Default setting is SINGLE)

If more than one systems are on the

same phone line, you must set each

system to MULTI.

Step 4 Enter the unlock time value (04-99 Seconds) then press #, the display shows

Step 5 Select another Function Code to program different field from the table or

press

to exit the programming mode.

Step 1 Log on to programming mode (see section 3.1). The display shows

Step 2 Enter Function code 03, then press #, the display shows

Step 3 Enter the Lock Out Count value (1-9) then press #, the display shows

Step 4 Select another Function Code to program different field from the table or

press

to exit the programming mode.

NOT APPLICABLE FOR NON SUBSCRIBER.

Step 1 Log on to programming mode (see section 3.1). The display shows

Step 2 Enter Function code 05, then press #, the display shows

Step 3 Enter 1 for SINGLE or 0 for MULTI, then press #, the display shows

Pach and Company Chapter 3 Page 14

AeGIS NPB9000 Series PROGRAMMING 05/01/02

UNLOCK TIME, SEC

ENTER: 12 PRESS #

SELECT PROGRAM

ENTER: _ _ PRESS #

SELECT PROGRAM

ENTER: _ _ PRESS #

LOCK-OUT COUNT

ENTER: 3

PRESS #

SELECT PROGRAM

ENTER: _ _ PRESS #

SELECT PROGRAM

ENTER: _ _ PRESS #

SINGLE=1 MULTI=0

ENTER: 1

PRESS #