Owner manual
FUNCTION CODE LOCAL PROGRAMMING
27
RS-232 or MODEM
(Default setting is 1 for MODEM)
You may program the system via
built-in RS-232 (local) or MODEM
(remote)
1= MODEM
0= RS-232
28
DIRECTORY DIGIT
(Default setting is 3-Digit)
The number of digit on the tenant
code (directory code) must be set
before the tenant database is
programmed on Function Code 20
and Function Code 30.
29
ALARM DELAY
(Default setting is 15 seconds)
• Report ALARM (00-90 seconds) if
Door 1 or DOOR 2 is open longer
than the Door Open Interval set on
Function Code 02 (door sensor
switch must be installed)
• Report ALARM (00-90 seconds) if
DOOR 1 or DOOR 2 is forced open
(door sensor switch must be
installed).
• Trigger relay 2 if set for MODE 2 (A
SHUNT) (00-90 seconds).
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 27 then press # and the display shows
Step 3 Enter 0=RS-232 then press # and proceed to step 5 or 1=MODEM then
press #, the display shows
Step 4 Enter 1 or 0 then press #, the display shows
Step 5 Select another Function Code to program different field from the table or
press
*
to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 28 then press # and the display shows
Step 3 Enter the directory digit (2, 3 or 4 digit) then press # the display shows
then the display shows
Step 4 Select another Function Code to program different field from the table or
press
*
to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 29 then press # and the display shows
Step 3 Enter 00 - 90 then press #, the display shows
Step 4 Select another Function Code to program different field from the table or
press
*
to exit the programming mode.
Pach and Company Chapter 3 Page 26
AeGIS NPB9000 Series PROGRAMMING 05/01/02
SELECT PROGRAM
ENTER: _ _ PRESS #
Rs232/Modem
0=232, 1=Modem: 1
Protocol: 1_V22
0=Bell212 :1
SELECT PROGRAM
ENTER: _ _ PRESS #
DIR DIGITS
ENTER: 3
PRESS #
% SORTING DATA %
Please Wait . . .
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
ALM DELAY: 00 - 90
ENTER: 1
5
PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #