Owner manual

ManualsBrandsPach and Company ManualsAccessories communicationAeGIS NPB9000 Series Manual

FUNCTION CODE LOCAL PROGRAMMING

DELETE KEYPAD ACCESS CODE

AND CARD NUMBER (RADIO

TRANSMITTER NUMBER)

• You must know the keypad access

code to delete this field.

CLEAR ALL KEYPAD ACCESS

CODE AND CARD NUMBER

(RADIO TRANSMITTER NUMBER)

Step 10 Select another Function Code to program different field from the table or

press

to exit the programming mode.

Step 1 Log on to programming mode (see section 3.1). The display shows

Step 2 Enter Function Code 32 then press # and the display shows

Step 3 Enter the 4-digit keypad access code then press # the display shows

XXXX= Keypad access code entered

Step 4 Press 5 to continue or

the display shows

XXXX= keypad access code deleted

if the keypad access code is valid

or Press

to CANCEL and proceed to step 5

if the keypad access code is invalid

THEN display shows

Step 5 Select another Function Code to program different field from the table or

press

to exit the programming mode.

Step 1 Log on to programming mode (see section 3.1). The display shows

Step 2 Enter Function Code 33 then press # and the display shows

Step 3 Enter 1=YES then press #, the display shows

proceed to step 4

Or Enter 0=NO then press # and proceed to step 5.

Step 4 Press 5 to clear all keypad access codes and card numbers, the display

shows

Pach and Company Chapter 3 Page 29

AeGIS NPB9000 Series PROGRAMMING 05/01/02

SELECT PROGRAM

ENTER: _ _ PRESS #

DELETE Access

Code: ____ PRESS #

DELETE XXXX?

Push 5 to Confirm

XXXX Now is Gone

Deletion Done !

ACCESS CODE XXXX

DOES NOT EXIST

SELECT PROGRAM

ENTER: _ _ PRESS #

SELECT PROGRAM

ENTER: _ _ PRESS #

CLR ALL Codes ?

YES=1 NO=0

Del ALL Codes !

Push 5 to Confirm