Owner manual

FUNCTION CODE LOCAL PROGRAMMING
40
MASTER CODE MASK
(Default setting is disabled)
WARNING !!!!!!!!
• Master Code cannot be recovered
if Master Code Mask is enabled. You
must request a new memory
(EEPROM) from Pach and Company
for nominal charge.
• The square RED button (retrieval
switch) on the board cannot recover
your existing master code.
41
OPEN DOOR BEEP
(Default setting is enabled)
• The system will beep if relay or
relay 1 (door 1) or relay 2 (door 2) is
unlocked.
42
ENABLE OR DISABLE PBX
(Default setting is disabled)
NOT APPLICABLE FOR NON
SUBSCRIBER (NPB 9000 SERIES)
Step 5 Select another Function Code to program different field from the table or
press
*
to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 40 then press # and the display shows
Step 3 Enter 0=NO or 1=YES then press # the display shows
Step 4 Select another Function Code to program different field from the table or
press
*
to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 41 then press # and the display shows
Step 3 Enter 0=NO or 1=YES then press # the display shows
Step 4 Select another Function Code to program different field from the table or
press
*
to exit the programming mode.
NOT APPLICABLE FOR NON SUBSCRIBER (NPB 9000 SERIES)
Pach and Company Chapter 3 Page 30
AeGIS NPB9000 Series PROGRAMMING 05/01/02
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
MC DISPLAY MASK
0=NO 1=YES : 0
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
Open Door Beep
0=NO 1=YES : 1
SELECT PROGRAM
ENTER: _ _ PRESS #