Owner manual

ManualsBrandsPach and Company ManualsAccessories communicationAeGIS NPB9000 Series Manual

HOW TO EXTEND THE

TALK TIME

HOW TO USE THE

CALL WAITING

HOW TO USE THE

DOORMAN OR

MANAGER PHONE

HOW TO USE THE

KEYPAD ACCESS CODE

HOW TO USE THE

CARD ACCESS OR

RADIO TRANSMITTER

The talk time can be programmed from 10 - 240 seconds. You will hear “ One Long

Beep” ten seconds before the talk time expires. The tenant must press #

immediately to extend the talk time to another cycle. For example: if the talk time is set

for 30 seconds, pressing # will extend for another 30 seconds. You can continue

pressing the # to extend the talk time after the “ One Long Beep”.

Press 0 on your phone keypad to answer the incoming call and put the exsiting call on

hold. NOTE: WORKS ONLY ON TONE PHONE.

o Place a call to tenant: press # then the 4-digit phone number (relay number, not

tenant actual phone number.

o Place a call using the outside line: because your phone is connected as a

doorman or manager phone, to place a call

using the outside line you must press 0 then

dial the phone number (actual phone number).

NOTE: WORKS ONLY ON TONE PHONE.

Step 1 Press

then the screen stops scrolling, if the screen is still scrolling, repeat this

step.

Step 2 Press a valid keypad access code and the door will unlock. If the keypad

access code is invalid the display shows

NOTE: If invalid codes are entered more than the number program on

Function Code 03, the display shows

the system will ignore further keypad access code entries for 90

seconds. If a telephone number is programmed on Function Code 09,

the display shows

and will call the number

programmed

Step 1 Place the card close enough to the red light emitting diode (LED) on the reader

or press the radio transmitter button

Step 2 The Card Reader will beep if the card is read properly and the green LED

blinks, the door will unlock if the code is valid or the display shows

NOTE: If invalid card access is used more than the number program on

Function Code 03, the display shows

If a telephone number is programmed on Function Code 09, the display shows

and will call the number

Pach and Company Chapter 4 Page 35

AeGIS NPB9000 Series SYSTEM’S OPERATION 05/01/02

ERROR Wrong Code

PLEASE TRY AGAIN

INVALID CODE! !

ACCESS DENIED

ERROR Wrong Code

PLEASE TRY AGAIN

INVALID CODE! !

ACCESS DENIED

ALARM ACTIVATED