Owner manual

HOW TO ADJUST THE
SPEAKER AND
MICROPHONE VOLUME
HOW TO ADJUST THE
LCD DISPLAY
HOW TO ADJUST THE
PULSE SENSITIVITY
HOW TO CHECK THE
NUMBER OF TENANTS
PROGRAMMED IN THE
SYSTEM
The speaker volume and microphone are factory preset. See figure 2.1 to locate the
speaker volume adjustment pot (VR2).
• COUNTER-CLOCKWISE TO INCREASE
• CLOCKWISE TO DECREASE
If you hear a "feedback" when you close the face plate, decrease the volume.
To locate the LCD adjustment pot, see figure 2.1 (VR3).
• CLOCKWISE TO INCREASE
• COUNTER-CLOCKWISE TO DECREASE
To locate the Pulse Sensitivity adjustment pot, see figure 2.1 (VR1).The Pulse sensitivity
is factory preset.
• COUNTER-CLOCKWISE TO INCREASE THE PULSE SENSITIVITY. An
Adjustment is necessary if the LED flashes or ON if the system is in a dial
tone mode (press #, to get a dial tone),
• COUNTER CLOCKWISE TO DECREASE, LED should goes off if the system
is in dial tone mode.
You cannot program the tenant's directory more than the system capacity. An accurate
tenant's record is essential. You must delete any unused tenant's directory to free the
system's memory. You may check the total number of tenant in the system locally (using
the unit keypad or optional AeGIS NPB9000 Management Software. The number of ten-
ants may not be accurate if the tenant name is not programmed. The steps below are
to check the number of tenants in the system locally. See the optional AeGIS
NPB9000 Series Management Software to check the number of tenants in the systems.
Step 1 Log on to programming mode by pressing the 0 and # simultaneously then
release, the display stops scrolling and shows
Step 2 Press
*
then the display shows
then the display shows
XXXX= total number of tenant
programmed
NOTE: A directory without a tenant name will not be counted in the total
number of tenant.
Pach and Company Chapter 4 Page 39
AeGIS NPB9000 Series SYSTEM’S OPERATION 05/01/02
SELECT PROGRAM
ENTER: _ _ PRESS #
%DATABASE SORTING%
Please Wait . . . .
DIR # USED: XXXX
Please Wait . . . .