Full Product Manual

Your Paint Zoom
®
Platinum multifunction paint sprayer is warranted to be free from defects
in materials and workmanship for one year from the original purchase date. Should the product
have a defect in materials or workmanship, we will repair or replace it without charge to you
(a shipping and processing fee will apply). To obtain service under warranty, simply call our
Customer Service Center toll free at 1.800.793.2303.
This warranty does not cover damage caused by accident, misuse or any use other than
as intended and described in this product manual, or damage resulting from failure to maintain
and clean this product as specified in this product manual. This warranty applies only to the
original purchaser of the Paint Zoom
®
Platinum.
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT, INCLUDING IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED IN DURATION TO THE WARRANTY PERIOD, AND NO WARRANTIES, WHETHER
EXPRESS OR IMPLIED, WILL APPLY AFTER THIS PERIOD.
Some states do not allow limitations on the duration of implied warranties, so the above
limitation may not apply to you. While this warranty gives you specific legal rights, you may
also have other rights which may vary from state to state.
CONTACT INFO FOR WARRANTY SERVICE:
Paint Zoom
®
P.O. Box 9169
|
Van Nuys, CA
|
91409- 8291
800-793-2303
|
paintzoom.com
[e-mail]
© 2021 Ideal Living, LLC. All Rights Reserved.
Patents pending worldwide.
TROUBLESHOOTING
ONE YEAR LIMITED WARRANTY
PROBLEM CAUSE SOLUTION
A. Little or no material flow 1) Nozzle clogged.
2) Suction tube clogged.
3) Material volume setting
turned too far to the right (–).
4) Suction tube loose.
5) Material is too thick.
6) Inconsistent paint.
7) Container is loose.
1) Clean.
2) Clean.
3) Turn to the left (+).
4) Reinsert.
5) Check viscosity.
6) Strain paint.
7) Tighten the container.
B. Material leaking 1) Nozzle loose.
2) Nozzle worn.
3) Nozzle seal worn.
4) Material build-up on spray
pattern dial and nozzle.
1) Tighten.
2) Replace.
3) Replace.
4) Clean.
C. Atomization is too coarse 1) Viscosity of material too high.
2) Material volume too large.
3) Nozzle clogged.
4) Too little pressure build-up in
container.
1) Thin.
2) Turn to the right (–).
3) Clean.
4) Tighten container.
D. Spray jet pulsates 1) Material in container
running out.
2) Material is too thick.
3) Pick-up tube loose.
1) Refill.
2) Check viscosity.
3) Tighten the Pick-Up tube
E. Pattern runs or sags 1) Applying too much material. 1) Adjust material flow or
increase movement of
spray gun.
F. Too much over-spray 1) Gun too far from
spray object.
2) Too much material applied.
1) Reduce distance.
2) Turn material volume setting
to right (–).
G. Pattern is very light and
splotchy
1) Moving the spray gun
too fast.
1) Adjust material flow or
decrease movement of
spray gun.
H. Large cloud of paint 1) Gun too close to surface. 1) Move gun away from surface
and reduce paint flow.
19
20