Installation Guide

Screw and Lock
washer
Gasket
Collar
Ceiling
Canopy
Remove
Loosen but
Do Not Remove
Canopy
Clevis
Pin
Motor
Housing
Collar Pin
Set
Screw
Canopy Bottom
Cover
Outlet
Box
Hanger
Bracket
Screws
Canopy
Outlet
Box
Hanger
Bracket
Screws
! !
WARNING
FAILURE TO COMPLETELY TIGHTEN THE
THREE SCREWS IN STEP 4 COULD RESULT IN
FAN LOOSENING AND POSSIBLE FALLING.
! !
WARNING
FAILURE TO PROPERLY INSTALL CLEVIS
PINS NOTED IN STEP 6 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING
5
Hanging Your Fan - cont.
Option 2:
Close-to-Ceiling Mounting
Figure 10
1. Remove the mounting bracket from the
canopy by loosening the four screws on the
top of the canopy. Remove the two non-
slotted screws and loosen the slotted screws
(Figure 10).
5. Secure the canopy to the hanger bracket as
shown in Figure 12 with four screws included
with your fan. Secure the canopy to the
hanger bracket with the four screws with your
fan.
2. Place the gasket over the remaining three
screws (for wet rated fans only), route the
wires exiting the top of the fan motor through
the canopy ring (make sure the slot openings
are on top), then proceed to place the ceiling
canopy over the collar at the top of the motor
(Figure 11).
3. Align the mounting holes with the holes in the
motor and fasten, using the three screws and
lock-washers.
4. Tighten the mounting screws securely.
Figure 11
Figure 9
Figure 8
8. Slide canopy up to the ceiling as shown in
Figure 9. Make sure you place the wires
safely into the outlet box. Secure the canopy
to the hanger bracket with the four screws
with your fan, snap canopy bottom cover to
canopy.
Figure 12
8002 ∙ 06/23/11 ∙ PCI