Installation Guide

Touching
Ceiling
Adhesive
Weight
Blade
Clip-On
Weight
12
Balancing Your Fan
Figure 24
The following procedure should correct most fan wobble.
Check after each step.
1. Check that all blade and blade bracket screws are secure.
2. Most fan wobble problems are caused when blade levels are unequal. Check this level
by selecting a point on the ceiling above the tip of one of the blades. Measure from a
point on the tip of each blade to a point directly above the blade on the ceiling. Measure
this distance as shown in Figure 24. Rotate the fan until the next blade is positioned for
measurement. Repeat for each blade. Measurements deviation should be within 1/8”. Run
the fan for 10 Minutes.
3. Use the enclosed Blade Balancing Kit if the blade wobble is still noticeable.
4. To use the kit, begin by adjusting the fan speed to nd where you get the most wobble.
5. Turn off the fan and then attach the clip-on weight about halfway down any blade.
6. Turn the fan back on to see if this has helped the wobble, continue moving the clip-on
weight from blade to blade.
7. Once you have isolated the “wobble” blade, start moving the clip-on weight up and down
the length of the blade (starting and stopping the fan each time) until you locate the correct
spot to stop the wobble.
8. Once the wobble has been located, place one of the adhesive weight on the upper side of
the blade where the clip-on weight was located.
9. Remove the clip-on weight, turn the fan on.
Figure 25
8002 ∙ 06/23/11 ∙ PCI