Installation Guide

Notes During
Assembly
Use a soft platform below the
parts to avoid scratches and damages.
Product dimensions can be
adjusted to your specific needs:
1.The wall-mounting profile
(top-back) can be adjusted from 260 to 305 cm (102.4" to
120") above ground.
The adjusting is done when
measuring and drilling (Step 7).
Please note the installation
recommendations' height suggested in Diagram A.
It is possible to fix the Patio
Cover back wall height at the lowest point of 260 cm/102.4".
This method is optional if
the assembly conditions and
exterior walls do not allow to follow the suggested
installation as appears in the manual.
Please note that the product
appearance may slightly change as a result, however snow
load weight does not change.
2. Poles distance from the wall
can be adjusted from 226 to 286 cm (89" to 112.5") as
suggested in Diagram B1.
Poles distance from the side
edges can be adjusted from 0 to 54 cm (0" to 21.3") as
suggested in Diagram B2.
The adjusting is done after
assembly and before anchoring (Step 21) by sliding poles and
profile 1041 at the roof
profiles' channels.
3. Wall mounting and distance
from the wall determine the roof angle and the total depth
of the product (distance of
gutter from the wall). Higher wall
mounting and shorter distance between wall and poles
increase the roof angle and
shorten the total depth as
suggested in Diagram C.
II]
Steps
Step 6: Apply silicone sealants on
the inner part of 8116 & 8117 and connect to the profile.
Step 10: Please apply silicone
sealants above beam 7288, in order to prevent water from
seeping in.
Step 13: Make sure that the
angle between the back wall profile and the panel supporting
profiles is 90 degrees.
Assembly of the panels should
start from the middle of the patio cover to each side
alternately.
Step 21: Please adjust the poles
(inside out and sideways) by sliding them to their final
position prior to anchoring.
Make sure that the poles distance
from the Patio cover side edge does not exceed 54
cm/21.3".
*Please note: Anchoring this
product to the ground is essential to its stability and rigidity.
It is required to complete this
stage in order for your warranty to be valid (Step 22).
*Tighten all screws when
completing assembly.
Note:
The wall anchoring kit supplied
with this product is suitable for concrete or solid brick walls only.
Other wall types need an
accordant wall fixation kit.
II
260-305cm
102.4"-120"
B1
226-286cm
89"- 112.5"
I
'
.
- 13°
.
+ 17°
'..
,..
+
-