Replacement Part List

Option #1:

Mounting the shelf in the

middle of the side wall

(Page 1)

(Not suitable for 4x6 shed)

Attention:

Option #2:

Mounting the shelf where the

shelf's left side connects with the

shed's corner (Pages 2-3)

V Do not mount more than 2 shelves onto one panel.

RtDo

not mount more than 4 shelves on a single wall.

RtUnder

any circumstance do not mount more than 10 shelves per shed.

Rt A single shelf can carry up to 30 kg (66 Ibs).

Option #3:

Mounting the shelf where the

shelf's right side connects with the

shed's corner (Pages 4-5)

Option #4:

Mounting the shelf side by side

(only at the shed's rear wall)

(Page 6)

e.41

--1w-I

(Not suitable for 4x6 shed)

During Assembly

Panel (#8076) is not pre-drilled; therefore you must drill the holes with

accordance to your chosen option.

RtMetal

plate (#8075) is used for mounting the shelf onto either one of the

shed's corners. If you did not choose this option, there is no need to use

this part; keep it for future use if needed.

V Tighten all screws when completing assembly.

Do not tighten screws and nuts (411 & 412) until completion of assembly process.

These 2 icons indicate if screws'tightening is required or not.